Crown 1160MA pojačalo

Crown 1160MA pojačalo

proizvođač: Crown

The 1160MA has 4 inputs and one 160W power amplifier for single-zone systems. Input routing allows each input to be assigned to any output. This drastically reduces the need for additional mixers or amplifiers (or both) when systems require either..

8

cena: 1106 $

Dodatna pitanja

info telefoni: 011/334-56-17, 011/3340-749, 063/586-473

Karakteristike

4 inputs, 1 amplifier output channel
Ideal for commercial and industrial use
Balanced Phoenix-type mic/line inputs; touch-proof screw-terminal speaker outputs
Any input can be sent to any output
Built-in four-tone generator
Priority muting
Independent bass and treble controls for each input
Minimum guaranteed power into 4 ohms or 70V/100V output 160 watts

Opis

Performance:

Frequency Reponse (at 1 watt from 4-ohm tap):
70 Hz to 19 kHz ± 1 dB.
Frequency Response (at line out):
20 Hz to 20 kHz ± 1 dB.
Power Bandwidth (at 4-ohm tap, 2 dB below maximum 1 kHz power):
50 Hz to 20 kHz with < 0.5% THD
Signal to Noise Ratio (ref. to rated power, master volume at minimum):
85 dB.
DC Output Offset:
< ±5 mV.
THD:
Less than 0.5% at rated power at 1 kHz.
Input Sensitivity (for full output at maximum gain):
Balanced mic inputs:
3 mV.
Balanced line inputs:
800 mV.
RCA connectors:
400 mV.
Input Impedance (nominal):
Mic: 400 ohms.
Line: 100 kilohms.
RCA: 50 kilohms.
Crosstalk: –70dB at 1kHz.
Line Output Level (nominal): 1V into 10 kilohms.
Phantom Power: 15 VDC.
AC Line Voltages Available:
100V 50/60 Hz
120V 60 Hz
220V 50/60 Hz
230V 50/60 Hz
240V 50/60 Hz
Operating Temperature/Humidy: 0° C to 40° C at 95% relative humidity (non-condensing).
Storage Temperature: –20° C to 85° C.
 

Front Panel Controls and Indicators:

Power Switch: Push button on-off switch. The power switch does not affect the 24V DC auxiliary power input.
Input Volume Controls: Microphone/line, four in 180MA and 1160MA, eight in 280MA. Detented potentiometers with knobs.
Tone Controls: Bass and Treble non-detented recessed potentiometers on each input channel. Bass ±10 dB at 100 Hz, Treble ±10 dB at 10 kHz.
Power Indicator: Blue LED indicates power on.
Input Signal Presence Indicator: Green LED, one for each input channel, illuminates when input signal exceeds –24 dBu (line) or –70 dBu (mic).
Output Signal Presence Indicator: Green LED, one for each output channel, illuminates when output signal level exceeds 100 mV (45 dB below full power) from the 4-ohm tap. Does not respond to signals from the AMP INPUT connector.
Clip Indicators:
Red LED, one per output channel. Illuminates at threshold of audible distortion. Does not respond to signals from the AMP INPUT connector.
Output Volume Controls: One per output channel. Detented potentiometer with knob.

Back Panel Controls and Connectors:

Reset Switch: Resets the circuit breaker that protects the power supply. 220/230/240V units have a fuse instead.
AC Power Inlet: Detachable IEC.
Auxiliary Power Input: 2-position terminal strip for 24 VDC (±10%) backup power. Accepts up to 14 AWG terminal forks.
Amplifier Outputs Connectors: One per channel,4-position terminal strip with COM (Common), 4 ohms, 70V and 100V terminals. Accepts up to 14 AWG terminal forks. Non-touch cover included.
Output VCA Connector: 4-pin Phoenix-type connector for two VCA control lines of +10 VDC and ground. Compatible with Crown 1-VCAP and 4-VCAP modules.
Amp Config Switch: A DIP switch with two functions:
1. Assigns an input as the priority input for each output, thereby temporarily muting the remaining inputs. Muting is activated by contact closure.
2. Global enable switch for phantom power. Does not affect RCA inputs. Default position is off.
Priority Connector: 3-pin Phoenix-type connector allows Input 1 or Input 5 (280MA only) to mute other input signals by contact closure.
Tone Generator Connector: 5-pin Phoenix-type connector. Tones include Pre-Announce Chime, Bell, Alert Tone, and Evacuate Tone. All tones are activated by contact closures on the connector. Internal jumpers can disable tones in an amplifier channel (excluding Pre-Announce Chime).
Tone Level: One potentiometer per output channel sets the volume of the tones. Tone level (except Pre-Announce Chime) is not affected by output volume controls or VCAs.
Chime Level: Potentiometer sets the Pre- Announce Chime level. The Pre-Announce Chime is mixed with Channel-1 signals, so its level also is affected by the master volume control and VCAs.
Input Connectors:
Mic/Line Connector: 3-pin Phoenix-type, balanced, one per input channel.
Dual RCA Input Connector: For stereo music signals, unbalanced, summed together, two connectors per input channel.
Amp Input Connector: 3-pin Phoenix-type, high impedance balanced, one per amplifier channel. Used to link an additional mixer to the mixer amplifierCan be used to connect an external processor.
Mic/line Switch: Selects mic-level or line-level signals. One switch for each balanced input.
Link In/Out Switch: Slide switch, one per channel.With the Link Switch IN, any signal applied to the Amp Input connector will be mixed with the input signal(s). With the Link Switch OUT, only the signal from the Amp Input Connector will appear
at the amplifier output.
Cooling:Convection cooled.
Protection:
Current Limit Protection: Included.
Thermal Limit Protection: Over-temperature thermal cutout.
DC-Fault Load Protection: Included.

Optional Accessories:
1-VCAP remote volume control for one channel.
4-VCAP remote volume control for four channels.

Dimensions:
EIA Standard 19-inch (48.3-cm) rack mount width(EIA RS-310-B) with rack ears, 3.5-inch (8.9-cm) height and 12.2-inch (31.0-cm) depth behind the mounting surface (not including non-touch cover). 4.1 inches (10.5 cm) high including feet. 13.9
inches (35.2 cm) deep from front of knobs to back of non-touch cover.

Weight
Net Weight:
1160MA: 25.3 lbs. (11.5 kg)
Shipping Weight:
1160MA: 30.3 lbs. (13.8 kg)

Komentari o proizvodu NOVO!Comments

Podeli sa drugima svoje iskustvo/mišljenje! Ne objavljuju se komentari koji sadrže: Psovke, vređanje, VELIKA SLOVA, lične poruke, oglase, reklamiranje i cene kod konkurencije.

blog comments powered by Disqus

Prodajete polovan muzički instrument?

  1. Donesite Vaš instrument kod nas i mi ćemo ga proceniti potpuno BESPLATNO
  2. Oglasite Vaš instrument na našem sajtu: www.polovniinstrumenti.com